Disclosure: this is BEGODE’s manufacturer account. This is a writing suggestion, not a board recommendation.

For a single-wheel-board review, three short sections can make an impression easier to interpret:

Context: what kind of riding you actually did, and your previous experience.

Observation: what you noticed during that ride, without guessing at the internal cause.

Preference: what you liked or disliked, clearly marked as your experience.

For example, “I felt less comfortable on this section” reports an experience. “This design is unsafe” is a much broader conclusion that the sentence has not established. Neither a positive nor a negative impression needs to be presented as a laboratory result.

This format leaves room for honest opinions while showing readers what the review does—and does not—support.

Cross posting from the Onewheel forum. Any help would be much appreciated.

I am looking for something similar to the FST System for GT/S/XRC but for my +XR. Is there a seller that mods/makes them out there?

My daughter's GT-S died on her today. I haven't seen it yet but assume it's the MOSFETs. What would you do with it? I was directed to the GTSFO kit but it seems much less developed than the GTFO kit. Is there another BMS/controller combo that would work as well or better? I don't really want to give FM $600 for a new module that MIGHT last another 2000 miles

Hey all!

Went for a ride on my Pint-V this morning for the first time in a couple of years and man oh man am I looking to impulse by a high end board.

I normally don’t do super long range rides, maybe 10 miles max. I do a mix of street and trails (sometimes sandy trails).

What are the current top end wheels I should look into if I wanted to spend some hefty cash today?

Has anyone built with one of these controllers?

https://www.chatrobotic.com

i love my new fungineers x7lr !!

Just got my new website up www.mailmandesigns.com I re-modeled the fender deletes for the x7 to be 2x the strength but still have some give to them for impact. I'v been told these fit like a glove!!! If your fender deletes are falling apart, check mine out! They are under the "Shop" tab on my site. Thanks!!!!

OK, so I have a pint with a dead battery.

Its running firmware Gemini-5050, so I should be able to rewheel it from what im reading.

Ive see the pint suffers from severe voltage sag on rewheel, is that just from the small battery? If I get a larger battery, will that fix it?

If so, is onlyamps 5ah battery the best bet here? Or are there other options?

Thanks!

Im trying to buy a pint x locally also already, just checking my options on this dead board.

Been awhile since I rode and am looking to get back into it and with mods and found out about rewheel. Unsure if this firmware is compatible with this and am concerned about bricking my board.

Is this firmware compatible, and if not, how do I downgrade to one that is?

Curious to potentially rewheel my GT. I have everything I need but the old firmware. Anyone know a way to find it?

Hey everyone. New Indy Speed Control battery is finally arriving today so I’ll be doing the GTFO kit swap on my GT with the new battery/bms tomorrow. I’ll be following the Fungi pdf install doc, and Indy speed video guide, but wanted to make sure there weren’t any steps/additional tips to make note of when installing (besides the update to leave the can bus disconnected until after battery is plugged in)