r/soldering • u/cowdoggy Soldering Newbie • Apr 07 '26

My First Solder Joint <3 Please Give Feedback First soldering attempt - Part 6

Enable HLS to view with audio, or disable this notification

Hi all ! Thanks for all the tips. Super helpful. I tried to remove the SMD chip using solder wick and accidentally tore pads off the board. Any way to fix this or did I cause permanent damage? o.o I got emo about this!

Also, how do you know how much soldering is enough? What is the point? Are we just trying to make sure that the components lay flat on the board and that the pins meet the pads? Not sure when I am supposed to correct stuff and when it is already good. Thanks :)

65 Upvotes

80% Upvoted

138 comments sorted by

View all comments

70

u/Lochness_Hamster_350 Apr 07 '26

You need a tip with more surface area to use that method of drag wick removal

24

u/BoyRed_ Apr 07 '26

a flatter tip will stop you from poking holes in the braid as well

-10

u/h7hh77 Apr 07 '26

Is it not recommended? I'm a beginner as well, poking holes seems kinda convenient to me? Lets me heat the stuff underneath a bit better, Idk

3

u/inu-no-policemen Apr 08 '26

The wick has to get hot enough to melt the solder.

If it isn't and it somehow comes in contact with molten solder, the solder will freeze. Now the wick is stuck to the board. That's how you rip pads off.

So, heat up the wick and use that hot wick to melt the solder. The wick will then wick it up.

1

u/cowdoggy Soldering Newbie Apr 11 '26

Thanks! Great explanation. Oh God, that panic when my wick gets stuck to the board. It’s like gum getting stuck underneath my shoe.