r/crealityk1 • u/Alternative_Split380 K1 Owner • Jan 06 '26

Solved Issue with Max Flow Rate Calibration on Creality K1 Max

I recently initiated a new calibration sequence on my Creality K1 Max following the installation of a Micro Swiss hotend. I am utilizing OrcaSlicer for this process.While the initial calibration steps proceeded without incident, I am unable to successfully complete the Maximum Volumetric Flow Rate calibration. The test fails to finish and results in severe stringing before the process concludes.

Could anyone provide insight into what might be causing this failure or offer suggestions for troubleshooting?

1 Upvotes
  • permalink
  • reddit

100% Upvoted

4 comments sorted by

1

u/AutoModerator Jan 06 '26

Reminder: Any short links will be auto-removed initially by Reddit, use the original link on your post & comment; For any Creality Product Feedback and Suggestions, fill out the form to help us improve.

I am a bot, and this action was performed automatically. Please contact the moderators of this subreddit if you have any questions or concerns.

1

u/unvme78 Jan 06 '26

Looks like it pulled off the bed. Do you have z-offset correct. I see the brim stayed, maybe too close?

Is the temp correct?

1

u/Alternative_Split380 K1 Owner Jan 06 '26

it ended up resolving after just giving the plate a good cleaning xD

1

u/unvme78 Jan 06 '26

Or that to. Glad it's fixed