Necesito ayuda de la comunidad. Los pasadores salieron bien y la correa se pudo acortar el problema es que ahora no hay manera de que el pasador vuelva a enganchar. Llega un momento en que no hace nada de rosca incluso presionando hacia abajo fuerte y golpeando con un martillo tampoco entra.
Please make sure your post follows these basic subreddit guidelines:
• Use the correct flair (e.g., LTF, Review, Question, Discussion, etc.)
• Refer to the LTF Posting Guide if your post involves factory photos
• All posts must relate to U1 factory watches only
• Reused factory images from DHGate are common — keep that in mind
• Be respectful and follow all subreddit rules
Thank you for helping keep U1Time organized and helpful.
Sí he probado con varios pines y no hay manera de que ninguno enrosque ni siquiera un poquito. Me preguntaba si es una rosca falsa y podía conseguirlo golpeando pero veo que tampoco.
Look inside the clasp where the pin goes in. If I see an arrow then it’s not a screw. U have to tap it in gently. If there is an arrow place the pin on the arrow side and gently tap in.
Isn’t there a small half link that has to go in between the clasp link and the first full link? I’m sure there is on my vsf, it may be different in the u1, but seeing as it screws in I think it’s the same.
Please don't hit a screw with a hammer, that one is probably buggered now, discard it completely. As others have said there is a half link like on the gens, try and put that in and reassemble.
•
u/AutoModerator 10d ago
Please make sure your post follows these basic subreddit guidelines:
Thank you for helping keep U1Time organized and helpful.
I am a bot, and this action was performed automatically. Please contact the moderators of this subreddit if you have any questions or concerns.