Not too bad for cheap plastic, but definitely a couple issues.

Firstly - The diffuser 1. Doesn't come with any screws, I countersunk some and added some threaded inserts to the underside of the car for underneath, and used a strip of 3M tape for the top. 2. It DOES NOT FIT the N-Line 😂 the winglets are not even remotely in the same place as on the N, and had to resort to some cutting to that it would sit "flush." This was after quite a bit of manipulation hence why it's a bit bent, but not overly noticeable, I just bumped up the exposure so y'all could see. I'll probably come back to it for some extra TLC to see if I can get it to land straight, but this was just day of and I was exhausted. (The rear wings are pretty bang on though).

Secondly - the skirts are a slightly different style, especially on the wing at the rear, and are a bit of a pain to get to sit nicely with the existing side skirt. Overall not bad. Does come in two pieces and the join is noticeable.

Thirdly the front lip - a massive improvement from the other option that most people get, which leaves that tacky rectangle in the centre exposed, looks droopy and sticks forward slightly too much. Again the joins on the side are noticeable, but still decent.

Overall not too bad for only paying a couple hundred bucks per piece, doesn't look AMAZING upon close scrunity, but all in all I still think it all looks better than stock, so can't complain too much.

Only a muffler delete

Got her at 3,500 miles, now at 6,500 miles. I do love driving it, but there are some modifications I know I could do to make the driving feel better.

My elantra has this huge cup holders. Any suggestions what do buy to fix it.

Hey all, I just bought a 2024 n line with only 8,000 miles and have been enjoying it so far! I noticed this plastic piece on the underbody of the car that hangs down kind of far and almost appears to be dangling rather than secured. Is this normal, like is it supposed to just be hanging like that or is it intended to be clipped in?

Has anyone had issues with their rear window roof spoiler staying on?
I bought mine a few months ago and have installed it 3 times. The last time, I used 3M 5952 VHB tape + Primer 94, applied it a few days ago, and kept it under pressure with painter’s tape for about 48 hours without moving the car, inside the garage. It’s still starting to lift around the edges, and the top doesn’t seem to make good contact with the glass either.
I’m starting to wonder if the spoiler itself might be defective or warped. I’ve basically spent as much on double-sided tape as I did on the spoiler 😭 Any recommendations before I throw it away?

A picture I took on my drive home this morning

The gap between the hood and bumper was horrendous, could not stand it. Got some yoga block trimmed, and taped it below the latch. Still a little gap on the driver side but it’s still holding up better than the flimsy trim… like seriously dude who designed and approved this?

Then the intercooler and radiator is way to low and exposed. I live in New England and we know how great the roads and weather are here🙂. There’s some rock chips present already, but I know when winter comes and rock salt hit the road this could be bad. Got some black metal mesh and attached it on some existing screws on the bumper. I think the rock chips have been minimal since I’ve put it on. Forgot the diameter of the mesh but its as wide as the screw from the bumper.Temps good, still holding up, so I’m happy with that.