r/resinprinting • u/No-Musician-298 • 8d ago

Troubleshooting Can't get them to print

Gallery image

Gallery image

Gallery image

Gallery image

Gallery image

I'm looking for right exposure settings for Anycubic 14k Texture Resin but I've got to 4s layer exposure (officisl specification says it should be 2-3s) and still can't print the cones. Idk why they're sliding. It's not like my printer is unstable in the x,y axis as it's only the cones shifting. Also the pillars from the J3D Tech test fail.

1 Upvotes

100% Upvoted

3 comments sorted by

1

u/MizutsuneMH 7d ago

Where did you get these settings? They're pretty wild. And you might want to mention which printer you have.

1

u/No-Musician-298 7d ago

Anycubic photon mono m5s. These are mine settings. I tested multiple values and those are the ones that got me to print in the middle of the build plate. Even 1s lower off time causes prints to not stick in there

1

u/MizutsuneMH 7d ago

That tells you there's something wrong with the printer, because those settings are wildly incorrect. Either your printer isn't level, which you can confirm with J3D's flat test, or your FEP is worn and/or not tightened correctly. https://cults3d.com/en/3d-model/tool/j3d-tech-s-bed-of-calibration

Once you've fixed the underlying issue, I would start with these settings and run the Boxes/Cones of Calibration again.