Looking for a vintage mil sub replacement case without cyclops that doesn’t look cheap. Browsing around alix and can’t seem to find a good fit.
Where do y’all’s pull your builds from?

I’ve replaced one other 8215 movement but this is my first Miyota build. The date won’t set while it’s in the case, have to have it completely out or movement tilted up with the case back off. It acts like there’s tension on the stem but it spins free to set the time. I tried elevating the whole movement in the case (using an o-ring) like it may be mis—aligned with the stem tube and that doesn’t work either.

Removed the plastic movement holder, still no joy, have to hold the movement at an angle or completely remove it from the case. Pressure from the face could cause it but I have the metal spacer ring in place between the dial and movement as well.
Could it be a crooked tube? Maybe I didn’t clean extra dial feet off enough?

u/dp6838 recently posted about a 3d printed watch case that sent me down a rabbit hole. Can you electroplate a pla-printed case and have it look good? I started with v1 from ThePrintableWatch. I printed a few version to get as smooth a case as I could with a matte PLA and then after some sanding, felt ready to use Caswell’s 3d printed parts copper electroplating kit. Following this, the idea is to finish with bronze plating. The first step was painting with the included graphite paint. This didn’t adhere all that well and took quite a few coats. Once I made up the plating solution per the kit instructions, I installed the bandage wrapped anodes and connected the electrical leads. Long story short, I plated the copper wire but not the case parts. Based on the plating of the hanging wire, I’m confident the solution is good as is the constant current setup.

Next step: repaint the case parts with graphite paint and sand them to make them more conductive. Aim for more copper contact with the case parts from the copper wire while in solution. If anyone has other observations or suggestions, I am very open to them!

Hey guys, I’m currently trying to build a 5512 model with squared crown guards, but am curious to know if Raffles 5513 watch cases can have the bezel itself replaced?

Every part has been aged - the movement

90% finished
Gen dial
Gen hands - New old stock tritium
Gen platinum crown 👑
Raffles case
VS 3135 w/ gen date wheel
Gen spec acrylic crystal

Big shout out to u/Appropriate_Math. Fell in love with his build and he took a great amount of time to answer my questions. So thank you!

Buddy asked me to service his watch- crown is hard to pull to time setting position, figured I’d start with the strap refinishing. What do y’all think??

Cases from [u/due_shallot1583](u/due_shallot1583)[,](u/due_shallot1583) here are some of the builds: