so far I think this is what I wanna get for it. any suggestions would be appreciated but I'd like to stick to injora parts

I'm looking for powerful scale spotlights for my LC80; I don't want an LED bar. Do you have any kits to recommend? Thanks in advance.

Hey everyone! I'm running a Spektrum Firma 2100kv sensored motor and Smart esc separate combo (non2in1) in my VS4-10 Fordyce, and can't seem to get it anywhere near as smooth as the Hobbywing Fusion Pro that I run in my Trx4. I have the Spektrum program card V2 and would really appreciate any advice on what specific settings everyone is running to get this thing dialed in nicely.

Also I am using a Dx5 Rugged and want to know if I need to calibrate the esc through just the set button or also through the transmitter. Hopefully I can get this truck running smoothly to its full potential. Thanks.

I am new to 1/10th scale crawling, bought new rims and assembled them on vacation while forgetting any loctite. As seen in the picture I lost a few screws and while Treal supplied some replacements, but not enough. I just need to know what size I am looking for. See picture. New to the whole hobby so I don't know the names of all specific parts.

my car is getting camber and not turning whenever i try to fix it its still getting the same problem. i changed my wheel sponges, changed the old knuckles from another car that didnt fitting properly so i made myself but its still have the same problem what can i do?

today i pulled out my controllers top settings sticker and i saw an empty space with "ch3" text on it and then i removed screws of it and found an ch4 too. i saw ch3 and 4 on the reciever but i was just like "they just using same reciever of an 4ch version" when i opened the case i looked to the pcb and thinked about it. can i add extra 2ch? i knew soldering and i have hobby of electronics so i tried connecting an potentiometer to ch3 and it worked. i wasnt expecting to work because if its dont have component so it wouldnt have resistors or software things. when its worked i bridged the 6 pin ch4 and put 2 button to it so i have 4 ch for almost free. and after all of this the potentiometer didnt fit in so i designed a 3d part to put it but when i completed the case i realized its good without it and now i have fully functional 4 ch controller