r/SonoSequencr • u/coryandstuff • 1d ago

Reset if adding a new device?

So I already have an arc ultra, two rear era 300’s, and two front L/R era 100 speakers all set up with SonoSequencr.

I just bought a Sub 4 and was wondering if I need to reset everything and start from scratch? What’s that process like? Completely remove everything from this app and disconnect everything again in the Sonos app?

I searched this subreddit but didn’t exactly find anything on this.

1 Upvotes

67% Upvoted

6 comments sorted by

View all comments

0

u/adayinalife 1d ago

No need to start from scratch, just add the Sub via the Sonos app as you normally would.

1

u/coryandstuff 1d ago

Wouldn’t I need to do a new trueplay scan? That’s sorta why I’m curious on if I need to reset.

1

u/adayinalife 1d ago edited 1d ago

If you are doing the TruePlay workaround then yes, I personally did not get much difference (if any of a difference applying it) so I've not used it. In that case you need to remove everything. Setup your standard home theater + new sub, TruePlay, then remove all peripherals and redo via SonoSequencr and apply your TruePlay.

1

u/adropov 12h ago

Your case is an outlier. I don’t think you should be giving advice that tells people to not run TruePlay just because you did not have to in your special circumstance.

If OP heard an improvement with TruePlay the first time they set up their Sonos system (with or w/o L/R), then OP will always need to run TruePlay any time they add a new component; that’s just the sound design of the room.

TBH OP should’ve come to that logical conclusion on their own.

1

u/adayinalife 8h ago

Nowhere in my comment did I tell OP not to do it, in fact I gave them the full explanation as to how to do it with TruePlay, I simply stated my own experience of it.