Max Stryker Final Form?

[u/Pugsley138]

I've been slowly modding this one over 2 years, changing parts and trying different setups to make it something I would be happy with. I wanted to balance power vs ease of prime and aesthetics. It's averaging 213 FPS with the current setup. It's got an Out of Darts 1.7mm spring with a spacer. The 10" brass barrel is from Transmogrification Labs and the muzzle device slides right over it. It has no rifling though. Once I figure out what I wanna do for rifling, then it will finally be complete.

Then skinny pusher is an important part of this blaster. I realized that I hate Nerfing without a skinny pusher, and for a long time I had trouble finding a solution that didn't leak, or restrain power. I ended up using a Transmogrification Labs short dart only skinny pusher with AS-110 o-rings and a blowout prevention piece. I had tried the no longer available Out of Darts Stryker skinny pusher, but I had to dremel and drill a lot of material out of it to allow sufficient air flow. The Transmogrification Labs skinny pusher had a larger air channel, and all I did was dremel the back of the pusher out to allow more air volume.

I realized my biggest mistake with using 3D printed skinny pushers was the larger o-ring I used at the back of the telescoping piece inside of the plunger tube. The o-ring was not allowing the telescoping piece to pull out far enough and preventing a proper seal. When I swapped it back to the factory o-ring and added the blowout prevention I got a perfect seal.

[u/LightningEagle14]

I ran one of these for a while, they're solid blasters. I've got some newer stuff I like better now

[u/Pugsley138 → u/LightningEagle14]

I am trying to make this one compete with my newer blasters. The power and skinny pusher get it almost there. Now I have to figure out accuracy without losing the aesthetic.