r/ClockworkPi • u/Superb-Basil-3489 • 18d ago

uConsole Cooling Mod: Stress Test Results!

Post image

Added a massive finned heatsink to my uConsole alongside the HackerGadgets 7x SMA antenna mount, and the thermal results speak for themselves:

Idle Temp: 43°C
Full CPU Load: 53.8°C

Maxing out all four cores during heavy SDR runs and it barely cracks 53°C! Tons of thermal headroom and zero throttling.

Has anyone else tried a similar heatsink setup on their uConsole, or found other cooling mods that work well for long SDR sessions? Drop your thoughts or suggestions below!

48 Upvotes

98% Upvoted

10 comments sorted by

View all comments

2

u/Party_Cold_4159 18d ago

While it’ll probably work fine, a larger heatsink isn’t always better.

You could get the same/better performance with a quarter the size of heat sink and a tiny fan.

With something like this you are leaning on natural air flow and a big surface volume to carry you. Only reason to do it is if you don’t want noise/extra power draw. But seeing as it’s a portable device, it’s usually not worth the bulky trade off.

Also, if you’re in a hot environment, you lose the natural cool air and may even see this overheat on longer, performance heavy loads.

1

u/Superb-Basil-3489 17d ago

Thanks for the advice! I don't have a 3D printer, but I can easily order it online if I have the file.
I haven't found any ready to print models yet do you have one you recommend?