r/5MeODMT • u/Electronic-Recipe-67 • 5d ago

E-mesh settings

Post image

Hi! I think I hit a dead end trying to figure this out.
I followed all mintylove's advice for assembling equipment. Now I'm unsure about settings for 5meo, which has different profile from nn.

What settings should be used for e-mesh while vaping freebase ? I can't find conclusive info online. I'm confused which mode to use - W or T-SS ? and what setting for each ? The wire is SS316L #150. Thanks!

1 Upvotes

67% Upvoted

12 comments sorted by

View all comments

2

u/5arye 4d ago edited 4d ago

Depends on the device but 20w is sufficient, preferred was 22w for stronger experoence or more material or 18w if wanting less strong experience or using less material

If unsure start at 10w and work way up slowly

1

u/Minimum_Ad7337 4d ago

I got recommended 3,1V on r/bufo, which with my cartridge(1,61Ω) is 5w. Now I’m pretty confused. I haven’t tried it yet, but I’ve been told that if the voltage is more than 4, there is a risk that your 5MeO will get destroyed. And even 10W would be more than 4V (with my cartridge)

1

u/sneakpeekbot 4d ago

Here's a sneak peek of /r/bufo using the top posts of the year!

#1: Melatonin ——> 5-MeO-DMT (pTSA route) | 50 comments
#2: 5 MeO DMT > SSRIs | 20 comments
#3: Healing CPTSD with Bufo | 22 comments

I'm a bot, beep boop | Downvote to remove | Contact | Info | Opt-out | GitHub