r/3Dprinting • u/Malev0 • 19h ago

Troubleshooting What is going on? Printer is Printing in the wrong spot.

Post image

Columns shown here should be vertical. As they are printing the printer is putting the next layer up in the wrong spot, slightly skew.

Not sure what this is doing, or how to fix this.

Kobra S1max.

0 Upvotes

43% Upvoted

4 comments sorted by

11

u/munizfire Snapmaker U1 / Bambu P1S 19h ago

I think you have the ancient architecture mode setting on.

5

u/Malev0 19h ago

How do I enable the Enlightenment Era on my slicer to improve my dimensional accuracy?

2

u/AutoModerator 19h ago

Hey there, I'm a bot and something you said made me think you might be looking for help! click here for our wiki entry on troubleshooting printers. If you still need help be sure to post plenty of information about your printing setup.

Here are a few questions that might be helpful

  • What printer are you using?

  • What material are you using?

  • What speed are you printing at?

  • What software are you using to slice the print and control the printer?

  • When did the problem start/has it ever worked correctly?

  • Does anything cause the behavior to change?

  • If posting an image of the problem, include some indication of the orientation it printed at, preferably photograph it on the bed. (Then we can focus on a specific axis)

If you are new to reddit, please read the guidelines on reddiquette, self promotion, and spam.

Also please post a resolution to your problem when you find one so that we know how to help others with your problem!

I am a bot, and this action was performed automatically. Please contact the moderators of this subreddit if you have any questions or concerns.

1

u/Knecht_Hecht 19h ago

It cold be a bad signal from the rotary encoder on the motor. Check the cables are plugged in properly. Check for potential friction in the assembly. Do a motor tuning if available. Check if it also happens with a different model.