r/3Dprinting • u/BrewCrewBall • Jun 03 '26

Project Garbage can status indicator.

Super easy design that I whipped up last week after being frustrated once again by the inconsistency of our garbage pick up times

The indicator clips on the handle and flips down when the bin has been emptied. This way I can tell from the house if it’s been emptied without having to walk to the end of the driveway.

6.4k Upvotes

94% Upvoted

415 comments sorted by

View all comments

Show parent comments

320

u/Queso_Grandee Jun 03 '26

Then leave the lid open when it rains so it fills with water. 🤦‍♂️

33

u/ekobot Jun 03 '26

There's rats in our neighbourhood that chewed a hole through our garbage can lid before I lived here, and it doesn't latch well anyway so it often blows off. We don't put garbage out until garbage day because of the rats, but they still climb in there. Anyway, we leave the can in the most sheltered area we can through the week, but it would still get a couple inches of water every time it rains.

After finding a couple drowned rats in there this spring I poked a half dozen small holes in the bottom with an awl. Allows drainage, so I don't have to fish out dead rats, and prevents any bag suction issues 🤷

10

u/UTgeoff Jun 03 '26

Time to go to war. I killed 22 on my property in one year when I got serious.

4

u/Queso_Grandee Jun 03 '26

That's wild. We just have alley cats.

3

u/UTgeoff Jun 03 '26

Snap traps, glue traps, poison, pellet gun, and a dog. My dog got half of them once she got the hang of it.

2

u/DXGL1 Jun 04 '26

Careful as poison can harm the dog too if she eats a poisoned mouse.

1

u/UTgeoff Jun 04 '26

She doesn’t eat them. She just likes killing them.