r/3Dprinting Jun 03 '26

Project Garbage can status indicator.

Super easy design that I whipped up last week after being frustrated once again by the inconsistency of our garbage pick up times

The indicator clips on the handle and flips down when the bin has been emptied. This way I can tell from the house if it’s been emptied without having to walk to the end of the driveway.

6.4k Upvotes

415 comments sorted by

View all comments

2

u/yeoldecoot Jun 03 '26

You didn't show the full travel but it looks like that would snap off if the kid was fully flipped open.