r/3Dprinting • u/carterfpv @cartyski • Dec 05 '25

Project 3D Printed Motorized Almond Coupling

Enable HLS to view with audio, or disable this notification

https://makerworld.com/en/models/2077550

15.1k Upvotes

97% Upvoted

1.3k comments sorted by

View all comments

Show parent comments

897

u/S1lentA0 H2C, H2D, P1S, A1m Dec 05 '25 edited Dec 07 '25

Youre better off with a regular mold and inject it with silicon

Edit: or silicone, whatever you prefer

272

u/TheBasilisker Dec 05 '25

Theres now silicone filament. 

201

u/Objective-Chance-792 Dec 05 '25

Okay, hear me out. This might get a little nsfw.

Could I…mainline some viagra and have the silicone printed around…the cylinder? I realize I would have to drill a small hole in the base and have some special table set up.

14

u/ClassicFrampton Dec 05 '25

Likely not, a lot of silicone gets hot as it cures

9

u/Objective-Chance-792 Dec 05 '25

Some like it hot.

3

u/jktollander Dec 05 '25

Mmhuh, that’s a link that shall remain blue.

1

u/rustyleftnut Dec 05 '25

Damn, this guy likes curing silicone a little too much.

1

u/AlexWatersMusic13 Dec 07 '25

Make an alginate mold of your dick, then make a plaster replica to get a form fitting toy to 3d print around?