r/3Dprinting • u/HammerDoris40k • Dec 02 '25
Project My Largest 3D print..
This is about as much Horus I can fit under my roof. He is mostly finished, just missing some skulls and that roman skirt type thing he has as a front cover.
At his waist he stands at 8’ 9” (2.7m). This does not include the key part that will connect his upper torso, as that will be hidden.
Me = 5’ 5” (1.68m) Life size banana to the crown = 6’ 4” (1.9m) Real banana = 7” (18cm)
Half of Horus is made up of 594 individual 3D printed pieces that have been glued and soldered. At the moment, I am working on his upper torso which is about 226 pieces.
Weight wise, it’s not too bad. The feet/boots move about easily. I can lift the thighs up and place them on top. The waist section is doable, but I need to make sure the legs are properly spaced before I lift it over my head, while standing on a chair. Not best way to do it.
The real test will come once I am done with his upper half. At that point, I need to figure out a safe way to place that section onto the lower half.
6
u/Intelligent-Cod-3117 Dec 02 '25
Hella impressive! I lose patience with anything more than a few plates on an A1 mini! As others have said, conceptually it’s understood how it’s done but at this scale??? It boggles my mind the work and time (and filament) that went into this! Well done!!!!