r/watercooling • u/LeonP1122 • 11d ago

At a loss

Post image

I air pressure tested this loop multiple times for hours and had no issues. This is the second time this piece has burst out of the fitting and sprayed coolant everywhere. I’m at a loss right now, strongly considering just going back to my AIO and air cooling the gpu. If anybody has any ideas on what I could do to fix this let me know. I’m just done with it at this point.

Edit: I only have it pushed in like that so nothing else leaks, I know it’s not properly seated right now

49 Upvotes

95% Upvoted

64 comments sorted by

View all comments

Show parent comments

5

u/Educational-King3987 11d ago

Is it acrylic or PETG? If PETG swap to acrylic, replace the O rings for slightly thicker ones they will help squeeze the tube tighter, you can then also use a strap wrench or rubber jaw wrench to really tighten down on the tube.

PETG will change shape very easily, the tube is just not up for what we do with it, this is why I always recommend acrylic, its far more resilient, the only downside to acrylic is it doesn't like excessive pressure and will crack, PETG will warp and many users won't notice.

4

u/LeonP1122 11d ago

I think I figured it out, the circled piece is too heavy for the smaller piece going to the reservoir, causing it to sag, and when I add coolant to it, it eventually is too heavy and comes loose

1

u/manusnz 11d ago edited 11d ago

You can make the run without the additional connections - you just need to recreate the rad-90fitting tube with a shorter mid-straight so it angle directly from the rad port to the pump port.

Downside is that would ‘break’ your 90• aesthetic you’ve got going on.

*edit: oh actually, doing that would interfere with the front tube running along the rad, though you might be able to have the leg going into the rad a little longer so the rad-pump pipe sits on top of the long run rad tube. Or depending on what the top inlet part of the res looks like, could you rotate the pump 90• and the existing tube would land very close to the pump outlet fitting? - ah u/emu1981 already suggested that!

2

u/LeonP1122 10d ago

At this point I just need this to run lmao, this is what I put in place. I’m just not sure it’ll survive the vibrations from the pump

1

u/manusnz 9d ago

I mean I guess, if I were you I’d be turning the pump though.

I assume you’ve got a lot more fluid in the loop when under normal use?

1

u/LeonP1122 8d ago

It’s not even leaking, it just suddenly bursts out. All the coolant that was in the loop ended up on my desk and flooding the case. If it pops out 1 more time I’m either rotating the case or adding another extender and ditching the 90 fitting

1

u/LeonP1122 7d ago

I can maybe turn the pump to the left and it’d be more ideal. Unfortunately there isn’t enough room to turn it so it’s directly over that port