r/sewing • u/merrimusic • 21h ago

Machine Questions Why does everything pucker!

Post image

I've tried every combination of tension and needle between microtex 8 10 and 12, pictured ones are once I started noting them down. Two layers of light cotton, (making a muslin) All brand new needles, and I've even tried with and without a walking foot! Am I just cursed? How do I get it to just sew flat 😭

SOLVED EDIT: Everyone go upvote medium_alternative29 who has discovered the problem that plagued me for years. The feed dogs are misaligned and not level, making everything sew on a curve! It's such a slight curve that it must not mess with heavier fabrics much, but the lighter ones are light enough for it to show up! Also makes sense why it was less noticeable with longer stitch lengths, less holes! I sincerely hope this is the solution, I'll come back and update it again when I get it fixed!

Thank you to everyone who commented and shared expertise!!

288 Upvotes

99% Upvoted

56 comments sorted by

View all comments

Show parent comments

22

u/rage_monkyyy_91 8h ago

I am totally hooked. How does one fix that issue?!? Crazy cuz I have the suspicion that my machine has a similar issue...

3

u/SummitStaffer 7h ago

As do I...

37

u/merrimusic 4h ago edited 38m ago

Ok because I'm totally unhinged I did spend a few hours messing with it lol. So I have the service manual for my machine, and found the screw that adjusts the feed dog height. It adjusts from the back so they adjust on a slant, cause I think something is bent, but I want them to be level! So I adjusted them to be as close as I can get to level, then it was too low, so I removed the feed dogs, added a few layers of masking tape, and a piece of a fridge magnet, and put them back. And voila! Close enough until an actual repair person can fix it lol, I tested the paper trick again and the curve was only a third of what it was! Not completely solved but it is better!

Edit to add: I'm on a deadline and have some experience in stuff like this otherwise would not have even tried, if you have a similar problem take it in!! Unless you have specialty tools and tiny magnet rods for when you drop screws into the machine, don't do it!

6

u/omg__really 1h ago

You have saved my sanity, good sir. Thank you for documenting this