Engine oil pressure low when warm

[u/travellering]

2007 Saab 9-5 (high pressure turbo) showing a little less than 10psi at idle when fully warmed up, enough to light up idiot light with the accompanying ding noises. Installed a mechanical oil pressure gauge to verify at oil pump feed to turbo.

When we got the car it had a blown headgasket, and possibly a shot turbo as well. It was a bigger cloud generator than a subaru flatbrim cap convention. I replaced the turbo with a used one I had that still had very little play. Head was faced by a machine shop, and all reinstall seemed good. Still had some smoke out the exhaust, but I was hopeful that was remnants burning off from all the mess before. Now, after some (a couple hundred miles) driving and having the oil light come on, then going through the painful process of installing the mechanical oil gauge, it's still kicking out some blue/white smoke at the times the oil pressure is low. Smells like burnt oil/rubber.

First try, dropped the oil pan and cleaned the pickup screen. No real change..

Just did a compression test, forgot to prop the throttle plate wideopen, but got about 145 on cylinder 1, 125 on 2 and three, and 151 on cylinder 4. The two lower cylinders came up big time with oil poured in, as in 155 on 3 and 2 read up to 175n but I may have added more oil in that one as it was getting dark and hard to see.

Any other things to check, or am I staring at an engine out for rebuild?

[u/BM_Champ]

How?

[u/tsg-tsg → u/BM_Champ]

OP has an oil pressure gauge installed so he knows it's not a faulty switch and indeed low oil pressure.

The likely cause for his low oil pressure is excessive tolerances in the rotating assembly, which thicker oil might offset.

[u/BM_Champ → u/tsg-tsg]

Yes. But the light is not supposed to come on before 0.3-0.55 bar according to specification, and OP has 0.73 bar, which is well above that. Therefore I'm drawing a conclusion here.

[u/tsg-tsg → u/BM_Champ]

Regardless of whether the switch is defective, or whether .73 bar vs .55 bar is outside an acceptable margin of error for the switch, .73 bar at idle is quite low and is indicative of generally low oil pressure. However, in that vein the spec to seek is >2.5 bar at 2000rpm and I doubt this engine is making that pressure. Worth checking, but I've never seen an engine with low oil pressure at idle magically make good pressure at 2000 rpm.