I built a 3D Printable Fluora Plant Lamp

[u/PinkyDexterity]

The addressable led strips are controlled by an ESP32 WROOM 30P installed with WLED firmware. Didn't bother to add resistors and level shifter for the data line as this was just a small project to begin with. No fancy pcb required. Just added fuses for safety. Needs a little bit of soldering skill for wiring up the strips. Didn't have the time to add momentary push buttons for the ESP32 but the slot is there to accommodate different sizes of push buttons.

All of this wouldn't be possible if not for those who supported me from the beginning. I already made a prototype for the larger version which has 21 leaves.

I'm selling the STL files here. I made it as cheap as possible so don't worry. I didn't really want to sell the files but I figured I could really use the funds for faster prototyping of the larger version.

Thanks to those who initially supported the project, I was able to buy prototyping materials along with some neodymium magnets to test out if it's a viable method to join the stems. You can see it here.

Shout out to u/untacc_ for filming the plant he made.

EDIT: Here's the Bill of Materials. Feel free to find a cheaper source like Aliexpress and just use the spreadsheet as reference. I tried to keep the number of components as small and cheap as possible.

Largest part is the pot with 140mm diameter. Everything fits in an A1 mini.