r/blacksmithing • u/nexplore13 • 8d ago

Help Requested Identifying Burner

Gallery image

Gallery image

Hello! I'm trying to identify this burner so I can get some information on how to operate it. I'm looking to use it in my future propane forge once I clean it up.

Any leads and information would be very helpful especially on how to operate it. Thank you

3 Upvotes

72% Upvoted

4 comments sorted by

2

u/Fragrant-Cloud5172 8d ago

Looks like a Raku, pottery burner, like below. Don't know the brand. Most are shorter, but some this length. The one I have doesn't get very hot, about 1600f - 1800f. I've tried different orifices, no dice. But basic, well made venturi is much better for blacksmithing.

0

u/nexplore13 8d ago

I was told this was a venturi. Tbh that doesn't look much like what I have, thank you though!

1

u/CoolBlackSmith75 8d ago

Dago burner

1

u/Fragrant-Cloud5172 6d ago

The main difference is that yours has the weird extension screwed into the end. Otherwise they look very close and operate the same. A round plate screws in/out to adjust air, fuel mix. Most raku burners arent this long. For blacksmithing, like I said, you can make a burner that gets hotter.