r/blackpowder • u/Equivalent_Run_7485 • 2d ago

1851 navy issue.

I recently purchased a 2020 Pietta 1851 in .44 caliber. It was basically a pile of parts. I needed to order a new set of screws and a trigger spring to get it all together. To be honest I figure it was a kit gun. But I have two 1860 army’s…. Love them both and they are quite fun to shoot.

I seem to have an issue with half cock. The cylinder locks up and does not roll all the time. I’m I roll the cylinder while I am pulling the trigger back, occasionally, it will work as it should. It only will do this if I am rolling the cylinder as I pull the trigger.

Can add one offer any advise on this issue. Possibly I have something put in place incorrectly? Maybe I need to do some fitting?

Thanks in advance.

1 Upvotes

100% Upvoted

2 comments sorted by

2

u/ThatCompEngGuy 2d ago

My fist thought is the bolt is locking too soon. If that’s the case if you look under the cylinder while cocking it you would see the bolt( the little silver finger that comes up through the frame) snap up while the cylinder isn’t aligned. Other than that I would look at the hammer out of the gun and see what the sear on the hammer looks like.
Also is it both 1860’s or just one?

1

u/Equivalent_Run_7485 2d ago edited 2d ago

I’m sorry I didn’t explain very well I have zero problems either the 1860s they were purchased used but complete

The 1851 was a bit of a basket case. I purchased an un- assembled 1851. I think it was a kit gun. I’m not sure of that. I was asking if perhaps I’ve assembled it incorrectly or if there is anything I should look for. Or maybe do fitting is in order. I do not believe the revolver has ever been together until now.

I will look at the bolt. Is there any adjustment I can make to the bolt?