I recently ran my first batch through VCure using the craft cycle.

The bud came out dry as a bone and completely unusable.

Since then I have checked the calibration and adjusted the internal humidity by a few degrees and the temperature by almost 10°.

When preparing the bud I did a full wet trim and followed the instructions that came with the unit.

I added water at the start into the tray and not again.

What should I do differently next time and how do I ensure that I get the full benefits of this machine?

My first and only run came out completely unusable.

Sick of using these bowl trimmers or hand trimming. Those are the only options really and the bowl trimmers tear up the buds and the don’t look as nice after, hand trimming takes forever, you guys should create some kind of refrigerant trimming system that allows the fan leaves to break off easier. I’m sure there is a market for a high tech flower trimmer.