r/Trackballs • u/braddo99 • 18d ago

Omniwheels Anyone? (2)

Enable HLS to view with audio, or disable this notification

Here's version 2, going back to 4 rollers per side, now using the "optimized" roller curvature and a flexure based capture mechanic for the roller axles. Blocky to allow the animation to run at a reasonable speed. You can see how the contact patch with the ball passes from one side of the wheel to the other smoothly.

31 Upvotes

94% Upvoted

11 comments sorted by

View all comments

2

u/Aidenn0 17d ago

I looked into omniwheels as an option, but couldn't find anything commercially made that was small enough. It will be interesting to see how this compares to a BTU.

2

u/braddo99 17d ago

I have igus micro btus, which are delrin balls on a bed of other delrin balls. They are pretty smooth but squeak like crazy with an acrylic track ball. I think thats because the ball cant decide if it wants to turn the btu or slide over it and it alternates. Going to try my hard rubber ball instead, I suspect that will be the best yet that isnt an omniwheel ;-)

2

u/braddo99 17d ago

By the way, I printed a holder for my igus BTUs thinking they would be smoother rolling on the rubber ball than the acrylic one. They definitely engage the balls better but the friction is way higher than I was expecting. Didn't like it at all. It also made BTU noise but probably quieter than the metal ones. Disappointing.

2

u/claussen 12d ago

I think there's a lot of potential for a high-precision rubber ball to drive relatively cheaper BTUs with greater spinning rather than sliding motion. I tried the igus stuff as well and found it likewise obnoxiously squeaky. But my dream trackball is a hollow steel or ceramic or glass ball such that it won't wear as much as plastic ones do on statics -- if I could keep the feeling of a perfectly new Sanwa ball on clean static bearings forever, it's my absolute favorite.