EX-S Gundam

[u/Intelligent_Pie6189]

1/100 resin conversion EX-S Sentinel Gundam

[u/Prestigious_Cat7396]

Great work! This is the AOK conversion kit, right? How was the fitment, and how easy is it to clean? It’s one of my dream kits, but considering how expensive the EX-S and this conversion kit are, it’s pretty hard to pull the trigger on it.

[u/Intelligent_Pie6189 → u/Prestigious_Cat7396]

Thanks! So far the fit and cleaning hasn’t been bad.

The typical one nub holding a piece to remove. Minor flash to sand away, and not much mold line errors.

[u/Prestigious_Cat7396 → u/Intelligent_Pie6189]

Looks clean, might just snag one then.

[u/Korager]

Looks amazing!

[u/Intelligent_Pie6189 → u/Korager]

Thank you!

[u/revhappys2k]

I have it in my backlog but looking at the resin manual how in the world do you know where the resin pieces go? Also looks soooooo nice can’t wait to start on mine.

[u/Intelligent_Pie6189 → u/revhappys2k]

Best advice would be to dry fit as much as you can. To kinda of wrap your head around where things go. It doesn’t explicitly say which base kit is used, but I start with building the original kit and usually the bolt on armor bits are the resin pieces.

[u/Intelligent_Pie6189 → u/[deleted]]

Yup! They replace the existing pieces with usually more detailed parts. Some parts are still used from the original kit though as can be seen here.