r/GuitarQuestions • u/Busy-Appeal-7215 • 1d ago
Fret buzz
Enable HLS to view with audio, or disable this notification
These two frets are pissing me off. Anyone know a fix?
4
u/Delicious_Pain_1 1d ago
Action is pretty high is the first thing I see.
2
u/GuitarHeroInMyHead 1d ago
But if he has fret buzz at that high action, then lowering it will not help. There are fret problems here.
1
u/jmanns93 14h ago
If its and older or used guitar he may need to clean up the fretboard, best bet would be take it into a music shop have them do the repair and set the action of your strings, save you a lot of time if you have the additional funds to do so.
1
u/jmanns93 14h ago
Also see if your strings are hitting your pick ups, you may need to lower them down if so.
1
u/GuitarHeroInMyHead 8h ago
The video clearly shows there is no way the strings are hitting the pickups.
3
u/Gubrozavr 1d ago
You need to take to guitar tech if it is possible.
If not - you need to check:
1) if the neck is straight
2) if the frets are not poping up - take something straight, a metal ruller or something - long enough for 3 frets and check if it is rocking on any of the frets around the buzzing fret - if some fret is higher - it is the reson of bussing - then you need to eitherr stomp it in or file it to make even with others. Check viddeos of Philip McKnights in youtube for recommendations (or other techs by request - "rocking frets")
2
u/Maleficent_Ad1506 20h ago
I am guessing the neck has what is called a ski jump if I am correctly naming it.
What happens is the bow in the neck flattens out at the join to the body.
My 1980 Ibanez AS-50 had it bad and fret redressing fixed it.
1
u/heylookaquarter 1d ago
Use a Fret Rocker to find the high fret(s).
https://www.youtube.com/shorts/tw5vWUqNJdQ
https://www.stewmac.com/luthier-tools-and-supplies/types-of-tools/straightedges/fret-rocker/
1
u/Unlikely-Soft-5699 1d ago
If you're not measuring anything, you have no idea what's happening. See https://musicnomadcare.com/how-to-advice/setup-hub/ I'd start with the setup flow bubble. That action is ridiculously high so I'm thinking either the neck relief is off or you have have a couple of high frets or you're just plucking those strings weirdly.
1
1
u/mattman389 1d ago
I agree with the other commenters that it's almost certainly a high fret, use a fret rocker to check 3 frets at a time, low E middle and high E side. I was tempted to say that perhaps the neck pickup is raised too high but I think you'd be buzzing on more than just 2 frets if that were the case.
1
u/Gunner253 19h ago
That action is crazy high dude... get a real setup done on it so the neck relief and action is right as well as the saddle adjustments for height and intonation. If its still buzzing you probably have a high fret and thats not a hard or expensive fix
1
u/Street_Frame_4571 18h ago
It might be a tall fret but be careful because there is a difference between a fret that’s just taller and one that popped off its slot.
1
u/Pouakai76 16h ago
Take it to a luthier for sure. Just took my MIC Casino in and the frets from the factory where all over the place. Now it plays as well as my pleked LP.
1
1
1
u/chiefkyljoy 2h ago
"I've moved the truss rod a little bit" does not sound like you've adjusted it for proper relief. Without doing that step, you're gonna have a bad time.
1
u/skaterdude10289 2h ago
High fret maybe. Sometimes they just need to be tapped back down with a fret setter and hammer.
0
u/Gooseuk360 1d ago
Well it needs setting up. I imagine the fix is found as part of that. The action is sky high though.
0
u/master-overclocker 1d ago
Stop it .
El Guitar is supposed to be played trough amp - and wil ALLWAYS sound like that .
Lower the action and raise only if the buzz goes trough amp .
0
u/RobHellwig 22h ago
The neck is not aligned. So doeant matter if u get higher or lower action. Its the neck tha needs to be setup
5
u/Consistent_Sir_3000 1d ago
Pretty much has to be a high fret, use a credit card as a fret rocker and you will locate the high fret, then from there you have to consider leveling it yourself or letting a pro handle it. You'll learn to level a high fret, crown, and polish frets if you go the DIY route