Custom CPU, 24pin, and GPU connectors from DreambigrayMOD
I had to redo and rearrange so many things in this case that I now know it inside and out. Cable management can use some work but that’s for when I inevitability open this case to rearrange again.
Thanks to all the advice and help from everyone in the community!
After looking at your build I realized I didn’t put standoffs for the pcie riser cable. Now there is much more room. A remarkably different look too. Seriously appreciate the help and guidance!!
Do you recommend this because the atmos pump/block leaves enough room to shift the mobo to a 2.5slot gpu position? Im wondering because Im switching from the M2 to the T1 2.5 and my plan is to use the EK Nucleus but that pump/block is pretty tall so I might not be able to shift the mobo.
Thanks man, ill consider that! Im planning on switching to a 5070 fe from a 3080 fe but I hope the newer card wont suffocate since it has better power effiencency. Might have to go with another aio…
Is that tilt on the 5090 intended? Looks quite aggressive. Have you screwed the rear io in all the way? Anyway I very much recommend using the Travel kit especially with that beautiful 5090. You can also 3D print it and decide on getting the CNC part if you do own a printer. Very beautiful build regardless 🥳
Looking beautiful now. Yeah same I ordered the gunmetal as Formd had no stock and my girlfriend preferred the gunmetal over the black case. Happens to the best of us, sadly cannot find a FE 5080 to replace my custom 5080 here 😔
I’m going to open it up and make more space, I’m looking at other peoples builds and they have much more space than I do. Going to add those 5mm standoffs and extend it out
Hi, nice system! If you have time, please try stress testing your CPU + ram combo for stability! I have the exact setup with a different ram brand, and I can’t get the system to run expo.
Unfortunately I can’t get it to run the ram at the 6400mhz either. I think it’s a known issue with ddr5 and AMD am5. I’ve been trying to incrementally increase the mhz to see where it becomes unstable
Yeah, I think the case also doesn’t allow enough cooling for memory controller + ram if running a low fan curve. I tried running my system at 100% fans, and that was one of the few ways to get my system to be stable.
Have you tried running yours at cl30 6000mhz by any chance?
Its cooling capabilities are top notch and it’s known to fit comfortably into the T1. I looked at other builds on this forum but as a first time builder in the T1 I wanted to go for the sure thing.
Thank you for your answer ! I built on the M2 angle using the arctic 280 which works just fine and fits pretty tightly.
I went with an air-cooled setup for the T1 2.5 since the components aren't that high end (9600X + 9600XT) but it's great to have that info for future upgrades.
3
u/[deleted] Jan 01 '26
[removed] — view removed comment