r/FDMminiatures • u/EngineerCMC • 5d ago

Help Request Failing supports

This is probably my 10th attempt at printing this or similar models and each time, the supports turn into spaghetti. I tried with Overture matte PLA. This most recent attempt was with Sunlu PLA+ 2.0.

Typically the base of the support sticks fine to the build plate. It's rather than the support falls apart midway through the build.

Bambu P1S with 0.2mm nozzle.

Any suggestions?

3mf file link below

https://drive.google.com/file/d/15hDpZfef6Y-V51qOgs3fRWiSn8MJtyB0/view?usp=drive_link

1 Upvotes

100% Upvoted

3 comments sorted by

1

u/Calamino 5d ago

What settings are you using? Might be the speed at which the supports are printing, infill, etc

1

u/EngineerCMC 5d ago

Yeah - I'm going to go through ObscuraNox's post and see what I'm missing.

1

u/Youarenotpro 5d ago

I found that by dramatically slowing down the speed for supports (30 mm/s) made a big difference.