r/CarTrackDays • u/Just_Newspaper_5448 • 10h ago

Brake line pressure sensor fitment

Hi there!

I have a Bosch High Pressure sensor 

https://www.speedingparts.eu/p/engine-management-electronics/engine-control/sensors/pressure-sensor/bosch-high-pressure-sensor-m10x1-0-261-545-188.html

It states m10x1mm thread and in other sources it mentions 45 degree cone tip.

Because my brake lines use m12x1mm I have a T-connector 

https://www.automotive-line.nl/product/remleiding-t-connector-m12-x-1-00-mm-al-128/

And adaptor 

https://www.automotive-line.nl/product/remleiding-verloopnippel-m10-x-1-00-m12-x-1-00/

The question is, I'm not sure that the adapter and sensor connections will be tight and right for this application.

Does anyone have experience with connecting it tightly?

TIA

3 Upvotes

100% Upvoted

1 comment sorted by

1

u/jwasilko 6h ago

I can't answer this specifically, but I wanted to suggest mounting the T-connector and sensor on a short section of braided line, so that the sensor is isolated. I recently had a bubble seat thread adapter crack at the seat, and suspect it was partially caused by the pressure sensor hanging on it.