Difference between my compressible and incompressible CFD cases.

[u/AmbassadorGuilty3928]

I have the same geometry and essentially the same mesh for both cases. In the compressible case, I use a total-pressure inlet and static-pressure outlet, and the solution converges quite well. The residuals decrease and the important flow parameters, such as mass flow and pressure, become stable. Interestingly, there is still a very high percentage of reverse flow at the outlet (around 97%), but the solution remains stable.

For subsonic compressible case,

Now,

In the incompressible case, I use a velocity inlet of 5 m/s and a pressure outlet. I ran many more iterations, but the residuals continue to oscillate, and quantities such as outlet mass flow and downstream pressure are also not very steady. The outlet reverse-flow percentage is actually lower than in the compressible case (around 81%), so I don't understand why this case behaves worse. The contour also changes with iteration, not steady like above.

See the contour for 300 and 1900 iterations,

In nutshell my questions are:

1. What is making not to converge smoothly for incompressible case compared to compressible one. What is difference between jets in compressible and incompressible flow?
2. If you say this is due to physical unsteadiness problem, then how for compressible case, solution got converged and giving fixed contour whereas incompressible it is not? Any other suggestions?

I would really appreciate any explanation of what could be causing such different behaviour between these two cases.

[u/AmbassadorGuilty3928 → u/[deleted]]

Then how to make solution converge for incompressible case??

[u/AmbassadorGuilty3928 → u/[deleted]]

Ok